Extron Electronics MAV Plus Series - Manual (Page 97)

Operation, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Operation 3-54
1 . Press and hold the Reset button until the front panel RGBHV
(CrossPoint 450 Plus)/Video (MAV Plus) and Audio buttons blink once
(events reset), twice (system reset), or three times (absolute reset) (figure 3-82).
I / O
RGBHV AUDIO
RESET RESET RESET
I / O
RGBHV AUDIO
RESET RESET RESET
I / O
RGBHV AUDIO
RESET RESET RESET
Release, then immediately
press and release again.
NOTE The Reset button on switchers with matrix sizes of 24 x 12 and above
have a different appearance and do not have a rear panel Reset LED.
Release, then immediately
press and release again.
IP Settings
Reset
6 seconds
Absolute Reset
9 seconds
Press and hold
the Reset button.
3 seconds
Events Reset
Front panel I/O buttons flash once.
Reset LED flashes once.
Release, then immediately
press and release again.
Reset LED flashes twice.
Press and hold
the Reset button.
Press and hold
the Reset button. Reset LED flashes
three times.
Front panel I/O buttons flash twice.
Front panel I/O buttons flash three times.
Figure 3-82 — Whole switcher and absolute resets
2 . Release the Reset button and then immediately press and hold the Reset
button until the LED flashes three times. Release the Reset button. Nothing
happens if the second momentary press does not occur within 1 second.
Performing a hard reset
The hard reset function restores the switcher to the base firmware that it shipped
with. After a hard reset, events do not automatically start, but user settings and
files are restored. Perform a hard reset as follows: