Powerplus POW64115 CHAINSAW 37.2CC 406MM EN - Manual (Page 12)

POW64115 EN
Copyright © 2011 VARO P a g e | 12 www.varo.com
Add oil to an approved fuel container followed by the gasoline to allow incoming gasoline to
mix with oil. Shake container to ensure thorough mix.
Warning: Lack of lubrication voids engine warranty. Gasoline and oil must
be mixed at 25:1
8.2.1 Fuel and lubrication symbols
8.2.2 Mixing ratio: 25 parts gasoline to 1 part lubricant
Gasoline liters 1 2 3 4 5
2-cycle oil ml 40 80 120 160 200
8.2.3 Recommended fuels
Some conventional gasolines are being blended with oxygenates such as alcohol or an ether
compound to meet clean air standards. The engine is designed to operate satisfactorily on any
gasoline intended for automotive use including oxygenated gasolines.
8.2.4 Chain and bar lubrication
Always refill the chain oil tank each time the fuel tank is refilled. We recommend using our
replacement chain & bar. Always use good quality sprocket oil, which contains additives to
reduce friction and wear and to assist in the prevention of pitch formation on the bar and chain
9 OPERATION
9.1 Engine pre start checks
WARNING: Never start or operate the saw unless the bar and chain are
properly installed.
fig 8
 Fill the fuel tank (A) with correct fuel
mixture.
 Fill the oil tank (B) with correct chain
and bar oil...
25 : 1
B
A