Eton Elite E100 - Manual (Page 16)

14
7 WORKING WITH MEMORY continued
E100 OWNER’S MANUAL
2. Tune to the desired station.
3. Press/release the Mem.&Edit button (15). Note that the
memory number digits (38) flash in the upper right corner of the
display. The memory page number, P#, also appears, but does not
flash.
4. Within 5 seconds use the numeric keypad to enter the memory
number that you wish to store the station into (In the factory’s
original memory setting, there are 25 memories per page. You
would therefore enter a number between 01 and 25).
5. Within 5 seconds press the Mem.&Edit button, or wait 5 seconds.
After a few seconds, the upper right corner’s display returns to the
clock.
SELECTING/CHANGING MEMORY PAGES
If you are not interested in changing memory pages and wish to keep
the original factory memory page setting, skip this section.
At the factory, the E100 is set up to access memory page 1 when
storing a frequency. You can leave this as-is or change to a differ-
ent memory page. We suggest learning first to store stations into
memory page 1 before changing to other pages. To do this, go to the
previous section, STORING STATIONS INTO MEMORY. To change to
the memory page, follow the directions below.
1. Press/hold the M.Scan/Page button (7) for about 3 seconds. Then
release it. Note that the memory page (38) is flashing in the upper
right corner of the display.
2. Within 5 seconds select the desired page with the Up/Hour and