Eton Elite E100 - Manual (Page 22)

20
E100 OWNER’S MANUAL
3. Within 5 seconds, enter 12 with the numeric keypad, then
immediately press/release the button labeled ENTER. ‘12H’ briefly
appears in the display.
DEFAULT FACTORY SYSTEM SET CODES
When shipped from the factory, the radio’s System Set Code Table is
set up as follows. Changes can be made via the procedure shown in
the section titled CHANGING SYSTEM SET CODES.
• Radio alarm uses last station tuned. Code 02.
• Eight pages with 25 memories (200 memories total). Code 08.
• 10 KHz AM (MW) tuning rate. Code 10.
• 24 hour clock system. Code 24.
• 1.5 Volt AA batteries. Code 29.
• 87-108 MHz FM frequency coverage. Code 88.
MONITORING CURRENT SET CODE STATUS
In the System Set Code Table, the current status of the set codes
identified with an asterisk (*) can be monitored by performing a
3 second press of the ‘Sys. Set’ button. The applicable icon shows
briefly in the display window for each code.
8 SYSTEM SET CODES AND THE SYSTEM SET
CODE TABLE continued