Powerplus POWXQ5330 MITRE SAW 1500W 254MM EN - Manual (Page 10)

POWXQ5330 EN
Copyright © 2013 VARO P a g e | 10 www.varo.com
9.10 Sawing
Make sure the saw blade doesn’t block while you are sawing. It causes
damage to and burning of the motor. If there is a blockade of the saw blade,
please loosen the switch immediately to prevent damage at the motor.
 Clamp the work piece firmly.
 Set the required horizontal mitre angle or the required vertical bevel angle.
 Switch on the power tool.
 Move the tool arm (18) slowly downwards. You have to push the safety switch (20) before
you can do this.
 Saw trough the work piece.
 Switch off the power tool.
 Wait until the saw blade (2) has come to a complete standstill before removing the work
piece.
9.11 Sawing special work pieces
Curved or round work pieces need to be secured against slipping.
Make sure there is no gap between the work piece and the fence (6) or the saw table (7).