Troubles shooting – Powerplus POWXQG7556 LAWNMOWER 190CC 560MM EN User Manual

Page 17

Advertising
background image

POWXQG7556

EN

Copyright © 2014 VARO

P a g e

| 17

www.varo.com

11 TROUBLES SHOOTING

PROBLEM

PROBABLE CAUSE

CORRECTIVE ACTION

Engine
does not
start.

Throttle chock not in the correct
position for the prevailing conditions.

Move throttle chock to correct
position

Fuel tank is empty.

Fill tank with fuel

Air cleaner element is dirty.

Clean air cleaner element

Spark plug loose.

Tighten spark plug to 25-30 Nm.

Spark plug wire loose or
disconnected from plug.

Install spark plug wire on spark
plug.

Spark plug gap is incorrect.

Set gap between electrodes at 0.7
to 0.8mm

Spark plug is defective

Install new, correctly gapped plug

Carburetor is flooded with fuel

Remove air cleaner element and
pull starter rope continuously until
carburetor clears itself and install
air cleaner element.

Faulty ignition module

Contact the service agent.

Engine
difficult to
start or
loses
power.

Dirt, water, or stale fuel tank.

Drain fuel and clean tank. Fill tank
with clean, fresh fuel

Vent hole in fuel tank cap is plugged.

Clean or replace fuel tank cap.

Air cleaner element is dirty.

Clean air cleaner element.

Engine
operates
erratically.

Spark plug is defective.

Install new, correctly gapped plug

Spark plug gap is incorrect.

Set gap between electrodes at 0.7
to 0.8mm

Air cleaner element is dirty.

Clean air cleaner element

Engine
idles
poorly.

Air cleaner element is dirty.

Clean air cleaner element

Air slots in engine shroud are
blocked.

Remove debris from shots.

Cooling fins and air passages under
engine blower housing are blocked.

Remove debris from cooling fins
and air passages.

Engine
skips at
high speed.

Gap between electrodes of spark plug
is too close.

Set gap between electrodes at 0.7
to 0.8mm

Engine
overheats

Cooling air flow is restricted.

Remover any debris from slots in
shroud, blower housing, air
passages

Incorrect spark plug.

Install RJ19LM spark plug and
cooling fins on engine

Mower
vibrates
abnormally

Cutting assembly is loose.

Tighten blade

Cutting assembly is unbalanced

Balance blade.


Advertising