Eiki/Elf EIP-4500 - Manual (Page 24)

24
Confirming the Projector
Status
(Status)
On this screen, you can confirm the projector
status. You can confirm the following items :
••••• MAC Address
••••• Power
••••• Condition
••••• Lamp Timer 1
••••• Lamp Timer 2
••••• Lamp Life 1
••••• Lamp Life 2
••••• Input
••••• Signal Info
Note
• If you click the “Refresh” button before the
screen is displayed completely, an error
message (“Server Busy Error”) will be dis-
played. Wait for a moment and then oper-
ate again.
• For details about each item, refer to the
owner’s manual of the projector.
Controlling the Projector via LAN
Controlling the Projector
(Control)
On this screen, you can perform projector con-
trol. You can control the following items :
••••• Power
••••• Input Select
••••• Volume
••••• Mute (Audio) [OFF] [ON]
••••• Black Screen [OFF] [ON]
Note
• If you click the “Refresh” button before the
screen is displayed completely, an error mes-
sage (“Server Busy Error”) will be displayed.
Wait for a moment and then operate again.
• You cannot operate this page while the pro-
jector is warming up.
• While the projector is in standby mode, you
can only control “Power ON”.
• For details about each item, refer to the
owner’s manual of the projector.