Eiki/Elf EIP-4500 - Manual (Page 40)

40
Stack Projection
Video equipment
Distributor
RGB cable
5 BNC to 15-pin
D-sub cable
Composite video cable
RGB
cable
LAN cable
(cross-over
type)
Projector 1:
Master
Projector 2:
Slave
OUTPUT (FOR INPUT 1, 2)
terminal
INPUT 1 terminal
INPUT 1 terminal
INPUT 2 terminals
INPUT 4 terminal
INPUT 4 terminal
LAN terminal
LAN terminal
Computer
Computer
Master
Set Inputs
ON
ON
OFF
ON
OFF
ON
OFF
OFF
ON
OFF
INPUT1
INPUT2
INPUT3
INPUT4
INPUT5
Slave
Set Inputs
INPUT1
INPUT2
INPUT3
INPUT4
INPUT5
Projector 1
Projector 2
6
Connect the INPUT 1 terminal on
the projector 1 to the RGB output
terminal on the computer using the
RGB cable.
(See page 27 on the owner’s manual of the
projector.)
7
Connect the OUTPUT (FOR INPUT
1, 2) terminal on the projector 1 to
the INPUT 1 terminal on the projec-
tor 2 using an RGB cable.
(See page 36 on the owner’s manual of the
projector.)
Note
• When connecting an RGB cable to the pro-
jector 2, use the input terminal that has
the same number as the projector 1. (IN-
PUT 1 terminal, in this case)
8
Connect the LAN terminal on the
projector 1 to the LAN terminal on
the projector 2 using a commer-
cially available LAN cable (UTP
cable, Category 5, cross-over type).
9
Turn on the projectors first, then
turn on the computer.
Application
When inputting multiple image sources, refer to the example below.