Eiki/Elf EIP-4500 - Manual (Page 39)

39
Stack Projection
Setting up the Stack Projection
Basic
This part shows an example for setting up the stack projection of a computer image with two projectors.
RGB cable
RGB
cable
LAN cable
(cross-over type)
OUTPUT (FOR INPUT 1, 2)
terminal
INPUT 1 terminal
INPUT 1 terminal
LAN terminal
LAN terminal
Computer
Projector 1: Master
Projector 2: Slave
Master
Set Inputs
ON
OFF
OFF
OFF
OFF
ON
OFF
OFF
OFF
OFF
INPUT1
INPUT2
INPUT3
INPUT4
INPUT5
Slave
Set Inputs
INPUT1
INPUT2
INPUT3
INPUT4
INPUT5
Projector 1 Projector 2
1
Set the “Stack Setting” of the pro-
jector 1 to “Master”.
(See page 84 on the owner’s manual of the
projector.)
2
Set the “Stack Setting” of the pro-
jector 2 to “Slave”.
(See page 84 on the owner’s manual of the
projector.)
3
Perform “Pair Stack” of the both
projectors.
(See page 85 on the owner’s manual of the
projector.)
4
Select inputs as specified in the
table below.
(See page 86 on the owner’s manual of the
projector.)
5
Turn off the both projectors.