Emerson 5-In-One Learning Light-Up Remote - Manual (Page 17)

17 Operation
USING THE LIGHT
Your remote has a backlight so you can see the keys in
the dark. To turn on the light, press
at the top right
of the remote.
When you press a key, the remote lights for a few sec-
onds. To turn off the light, press
again.
USING CHANNEL SCAN
Important: If you have set up SCAN/FAV for Favorite
Channel Scan, you cannot use Channel Scan until you
have reset
SCAN/FAV (see “Resetting Scan” on
Page 11).
If you want to view a sample of every channel on your
cable or SAT/DSS service, press
CBL/SAT , then press
SCAN/FAV . Starting with the current channel, the remote
control tunes to each channel in ascending order every
three seconds. Press any key to stop the scan.
Note: For on-air broadcast scans, press TV , then press
SCAN/FAV to start the scan.
USING FAVORITE CHANNEL SCAN
To scan favorite channels, you must first program the fa-
vorite channel table (see “Programming Favorite Chan-
nel Scan” on Page 10).
Press the desired device key ( TV or CBL/SAT ), then
press SCAN/FAV . The remote tunes to each favorite
channel in ascending order every three seconds. Press
any key to stop the scan.
USING MACROS
Press the desired macro key once for the first channel
you programmed (see “Programming Macros” on
Page 12), twice for the second channel, and so on.
USING THE POWER KEY
To turn on all devices, hold down POWER for at least 2
seconds. Each device turns on in the sequence you pro-