Ecom Instruments Ex-Handy 05 - Manual (Page 4)

39
1. Application
The Ex-Handy 05 is an intrinsically safe, splash water-, dust- and impact-resi-
stant mobile phone for industrial application in areas with an increased risk of
explosion in zones  and 2, in accordance with directive 999/92/EC (ATEX 37).
2. Safety information
This operating manual contains information and safety regulations which are to
be observed without fail for safe operation in the described conditions. Non-ob-
servance of this information and these instructions can have serious conse-
quences or may violate regulations. Please read these operating instructions
carefully before starting to use the phone!
In case of any doubt (in the form of translation or printing errors) the German
language operating instructions shall apply.
3. Faults and damage
If there is any reason to suspect that the safety of the unit has been impaired, it
must be withdrawn from use and removed immediately from the Ex-area.
Measures must be undertaken to prevent it from being restarted accidentally.
The safety of the unit may be compromised, if, for example:
- there is visible damage to the housing.
- the unit has been subjected to excessive loads.
- the unit has been improperly stored.
- the unit has been damaged in transit.
- unit markings or inscriptions are illegible.
- malfunctions occur.
- permitted limit values have been exceeded.
4. Safety regulations
Use of the explosion-proof mobile phone Ex-Handy 05 assumes that the operator
complies with conventional safety regulations and has read the certificate in
order to eliminate faulty operation of the unit.
The following points are to be observed:
- The device may not be opened inside the Ex-area.
- Only the original battery module Ex-AMH 05 (Li-ion 3.7V/850 mAh)
may be used!
- The battery module may not be changed inside the Ex-area!
- The battery module may only be charged outside the Ex-area and only then
using the following appropriate chargers: charger LGH 05, car charger ALH 05,
Car-Kit CKH 05 or USB data cable PCH 05.
- When changing the battery the battery compartment and the circulating seal
are to be examined for any contamination and cleaned, if necessary, with a
brush or by using blasts of compressed air.