Electrolux EWF 6120 W - Manual (Page 20)

care and cleaning 47
Proceed as follows:
• Disconnect the appliance.
• If necessary wait until the water has
cooled down.
• Open the pump door.
• Place a containfer close to the pump
to collect any spillage.
• When no more water comes out,
unscrew the pump cover and remove
it. Always keep a rag nearby to dry up
spillage of water when removing the
cover.
• Remove any objects from the pump
impeller by rotating it.
• Screw the pump cover fully in.
• Close the pump door.
Warning!
When the appliance is in use and
depending on the programme selected
there can be hot water in the pump.
Never remove the pump cover during a
wash cycle, always wait until the
appliance has finished the cycle, and is
empty. When replacing the cover, ensure
it is securely retightened so as to stop
leaks and young children being able to
remove it.
Cleaning the water inlet filter
If your water is very hard or contains
traces of lime deposit, the water inlet
filter may become clogged.
It is therefore a good idea to clean it
from time to time.
Turn off the water tap. Unscrew the
water inlet hose. Clean the filter using a
hard bristle brush. Tighten up the inlet
hose.
The dangers of freezing
If the machine is exposed to
temperatures below 0°C, certain
precautions should be taken.
• Turn off the water tap.
• Unscrew the inlet hose.
• Place the end of the inlet hose in a
bowl placed on the floor and let water
drain out.
• Screw the water inlet hose back on.
• When you intend to start the machine
up again, make sure that the room
temperature is above 0°C.
P1090
126.2931.23…EWF6120W.qxd:- 10/03/09 15:43 Página 47