Electrolux EWF 6120 W - Manual (Page 27)

54 installation
Installation
Transit security bars
Before starting the machine up, the
transport security bars must be
removed
as follows:
You are advised to keep all the transport
security bars. In case the appliance has
to be transported again.
1. Unscrew and remove the three rear
screws by means of a key.
2. Open the porthole, and remove the
polystyrene block fitted with the
adhesive tape on the door seal.
3. Place the machine in an upright
position and remove the three plastic
bolts.
4. Plug the 3 holes with the plastic plugs
which you can find in the envelope
containing the instruction booklet.
Hydraulic connection
There should be a COLD WATER tap
near the washing machine with a
screwing on connection pipe of 3/4 gas
for the water supply, a sink, a wash
basin or a drainage system in the wall.
Previously check if:
- it is not a hot water tap.
- the running water is clean. If not, run
off a reasonable amount of water to
flush out any debris that may have
collected in the pipes.
Have the permanent drainage system in
the wall checked by a plumber.
1. Carefully screw the pipe to the tap
taking care not to damage the
screwdrive and fix the nut well on to
the end in order to avoid leaking.
2. If necessary turn the hose adequately
by unscrewing the nut at the rear of
the appliance. Now tighten the nut
anew to avoid leaks. (Open the tap
and assure that it does not leak and
close it again.)
P0021
P1090
126.2931.23…EWF6120W.qxd:- 10/03/09 15:43 Página 54