Kichler 300144 - Manual (Page 10)

9
Fig. 18
Fig. 19
Step 1. Install the 3, 40 Watt/E12 T3 Krypton
lamps (provided). (Fig. 19)
Step 2. Remove the decorative nut from the
light fixture stem. Place the glass shade over
the light fixture stem and secure the shade
with the decorative nut. DO NOT OVER
TIGHTEN. (Fig. 19)
12. INSTALLING THE LAMPS AND
GLASS SHADE
Screws
Lamps
Light plate
Light plate
Socket plate
assembly
Wire connectors
Glass
shade
Decorative nut
11. INSTALLING THE SOCKET PLATE
ASSEMBLY
NOTE: Before continuing installation, confirm
that the power is still turned off at the main
circuit breaker or by removing the correct fuse.
Turning the power off using a wall switch is not
sufficient to prevent electrical shock.
Step 1. Loosen the two mounting screws on
the inside of the light plate then remove and
save the third screw.
Hold the socket plate close to the light plate
and connect the white wires from the socket
plate assembly and the fan by pushing the
connectors together. Follow the same
procedure with the black wire connectors.
(Fig. 18)
Step 2. Tuck the connections neatly into the
light plate. Place the key holes on the socket
plate assembly over the 2 screws previously
loosened from the light plate, turn the socket
plate assembly until it locks in place at the
narrow section of the key holes. Secure by
tightening all three screws. (Fig. 18)
Socket plate assembly