Kichler 300144 - Manual (Page 11)

10
Fig. 20
Fig. 21
Fig. 22
14. OPERATING INSTRUCTIONS
Remove the battery compartment cover on the
back of the CoolTouch™ Transmitter and insert
both batteries provided. Make sure the + sign is
facing up.
Take care during this procedure NOT TO move the
frequency dip switches inside this compartment.
The settings MUST remain the same as the
settings on the receiver for proper communication
with the control system.
It's a good idea to remove these batteries if your
fan is not used for extended periods of time,
(months).
NOTE: Make sure Dip Switch #5 is set to the X
position. This disables the dimming function. You
light fixture utilizes CFL lamps that can NOT be
dimmed.
13. INSTALLING THE BATTERIES
Fitch TM
Slide switch
Restore power to ceiling fan and test for
proper operation.
A.
, , and buttons:
These three buttons are used to set the
fan speed as follows:
= High speed
= Medium speed
= Low speed
B. button:
This button turns the fan off.
C. The " " button: turns the light fixture
On/Off or controls dimming. Press and
release for On or Off, Press and HOLD
for full range dimming.
NOTE: As stated above, the light dimming
function on this control is operated by holding
down the light button and releasing it at the
desired brightness level.
This control system is NOT designed to
"Reverse" the rotation of the blades. To set
the fan blades in reverse, the reverse slide
switch is located on the top of the Motor
Housing. See Fig. 22
ON
1 2 3 4
D
X
ON
Code Switch