Crivit V210 - Manual (Page 3)

5 6
INTEGRAL HELMET WITH FOLDING VISOR V210
We hereby congratulate you on the purchase of this motorcycle helmet. Please read the fol-
lowing instructions and information carefully before using your new helmet and keep these
operating instructions in a safe place for later reference!
Important information
Our helmets are manufactured in accordance with the latest technology and are specifically
designed for motorcycling. Whether the owner deems them to be suitable for any other use,
is up to him. Wearing a helmet does not exclude the possibility of injury should an accident
occur.
To guarantee adequate protection this helmet must be well fitting and securely fastened. Every
helmet that is exposed to a hard blow must be replaced.
We guarantee that this item is free of production and material defects. The guarantee does not
apply to normal wear and tear and or in case of improper use.
Scope of Delivery
The scope of delivery for your helmet consists of the following:
- Additional pair of cheek pads for individual size adjustment
- Replacement visor
- Acoustic damping
- Winter Collar
- Air Deflector
Instructions for use
Safety advice
- Warning:
During the journey, the helmet must be worn with the chin section closed.
- The helmet features a tilting sun shield that may only be used in combination with the visor.
- To open the chin section, press the chin section opener (6) and lift the chin section up at the
same time ( see Fig. A ).
- To close the chin part, pull the chin section down until it audibly locks into place.
- The retention system must always be carefully set and locked.
- Never wear scarves or other headgear underneath the retention system.
- Always ensure that there is no airflow restriction inside the helmet.
- Ensure that your visor is clean and scratch-free at all times. Never use smoked visors at night
or when visibility is poor. Exchange damaged visors for a genuine replacement immediately.
Your safety is at risk.
You are able to obtain replacement visors from the stipulated service address for a period of
5 years from the purchase date. Visor type: V210
- Never make any changes to any part of your helmet. Do not make any alterations to the outer
shell, do not insert screws.
- The helmet may not be painted or have stickers or labels.
- The helmet is designed to absorb the energy of a blow or a collision by destroying some of its
components. In case of a further blow it wouldn’t protect you any longer. After an accident,
the helmet must be replaced even though it doesn’t show external damages.
- Refrain from transporting your helmet by hanging it onto any part of your motorcycle. Keep
it away from exhaust pipes and other sources of heat.
- Never use solvents, petrol or other detergents when cleaning the shell and interior of your
helmet. Only use water and pH balanced soap. The padding can be cleaned using soap and
a small brush. The visor should be cleaned with soap and water only, leave it to air-dry. Do
not expose the visor to any source of heat!
- Only use genuine spare parts for your helmet.
Product Characteristics
ECE-R 22 Homologation
This helmet is in compliance with ECE-R 22.05 standards and is homologised
accordingly. The ECE-R 22.05 standard consists of uniform conditions for the
approval of protective helmets and its visors for drivers and passengers of mo-
torcycles and mopeds. The basic principles for these tests are the so called ECE-
Regulations of the Economic Commission for Europe.
Significant Tests of the ECE-Regulation 22.05
- Shock absorbance
- Dynamic test of wear features
- Field of vision test
- Design strength
- Sustainability test (Strip-off test)
- Chin straps and lock test
- Shear test for outside edges
- Friction performance test of the outer shell
- Visor test (mechanical and visual characteristics)
- Chin bar, chin part damping test
A