Crivit 6-13 - Manual (Page 36)

36
Dismantling the bathing boat
Deflating
Deflate the bathing boat as follows:
1 . To deflate the garret pull out the plug-valve and slightly push the shaft together or use the venting
pipes .
2 . To deflate the safety and flotation chamber / unscrew the screw-on-valve from the base
completely .
Kit bag
A duffle bag is delivered with the item in which the bathing boat can be transported and stored in .
Use the cord 200cm to close it .
In addition the duffle bag can be taken on board to protect provisions, cloths etc . from splashes of
water . Please take into consideration though that the item is not waterproof .
Therefore do not store sensitive objects such as cameras in it .
To make use of it on board it is recommended to remove the cords, to roll up the top end flat and to
close it up with the Velcro closure .
Storage bag (ill. 8)
In addition a splash-proof storage bag is also supplied, which
can be attached to the inner wall of the boat with Velcro closures .
Smaller items can be stowed in it to keep them dry; this item however
is also not entirely waterproof . Therefore, do not place any sensitive
items in it either .
Transport
Always transport the bathing boat with two persons and make use of the cords on the stern as well as
the handle bow .
Care / Maintenance / Storage
CAUTION!
Only make use of detergents that do not contain acids or petrol and never make use
of products based on silicone.
1 . Thoroughly clean your bathing boat after every use by rinsing it with fresh water and a mild soap to
remove salt crystals, grains of sand and other small impurities . Allow to dry completely afterwards .
2 . Fold up the boat with care .
3 . Store the bathing boat in a clean and dry area out of direct sunlight and at which it is not subject to
large temperature fluctuations . Make sure that it is not deformed and stored level and out of the reach
of rodents .
ill . 8
INSHORE 290