Crivit Z31222 - Manual (Page 86)

86 GB/MT
Setting the altimeter
Press the SELECT button 2 in altimeter mode until the display „ALTI“
appears.
Press the SET button 3 and hold for about 3 seconds. “HOLD TO
SET” appears in the display The altitude display then starts to flash.
Press the SELECT button to set the altimeter.
Press the SET button to proceed to the next digit.
Press the MODE button 1 to confirm the setting.
Note: Press the SELECT button 2 to select the desired display in altime-
ter mode. If you then press the SET button 3 , the following data appears
in the middle area of the display: temperature, time and graphic altitude
display.
Time
Note: You can have your current location displayed in different ways:
1. Simple display mode: current altitude and time,
2. Detailed display mode: temperature, time, current altitude and graphic
altitude display.
Press the SET button 3 to proceed to simple display mode.
Press the SELECT button 2 until the display „CLOCK“ appears. The
current time appears in the bottom area of the display, the current
altitude appears in the middle.