Miomare LED Washbasin Fitting / LED Bath/Shower Fitting - Manual (Page 31)

31 GB
Introduction / Safety information / Installation
2 Flexible connection hoses with seal 3 / 8“ ( 10 , 20 )
1 Pop-up pull rod with screw joint ( 3 – 5 )
1 Pop-up coupler 11
1 Pop-up pivot rod 12
1 Pop-up ( 13 – 19 )
1 Socket head wrench 21
1 LED installation spanner 22
1 Instructions for assembly / operation
Safety information
DANGER TO
LIFE AND RISK OF ACCIDENTS
FOR INFANTS AND CHILDREN!
Never leave children unattended with the pack-
aging material. Danger of suffocation. Keep this
product well away from children. This product
is not a toy.
BEWARE OF ELECTRIC SHOCK!
Leaking or water discharge can lead
to life-threatening danger due to
electric shock. Carefully check that all connec-
tions are watertight. Also ensure that all wires
of electric appliances are correct and have
been securely installed.
CAUTION! RISK OF INJURY! Please ensure
that no parts are damaged and that all parts
are correctly assembled. Incorrect assembly
could lead to injury. Please note that washers
and gaskets are wear parts and therefore will
need to be replaced from time to time. Dam-
aged parts could impact safety and function.
CAUTION! DAMAGE TO THE ARTICLE!
Please have all installations performed by skilled
individuals.
Be sure all seals are correctly seated.
SCALDING RISK! When adjusting the hot
water temperature be sure the water tempera-
ture is not too high.
CAUTION! Be careful not to revere the hot /
cold water plaque 25 . The correct placement is:
left = red (hot),
right = blue (cold).
Please note all seals are wear items and will
therefore need to be replaced over time.
Any leakage or sudden escape of water can
cause considerable damage to buildings and
property. All connections must therefore be
checked carefully to ensure that they are tight.
Familiarise yourself prior to installation with all
local conditions, e.g. water connections and
shut-off device.
The product is only suitable for use in rooms
with a temperature above 0 °C.
Installation
Note: Familiarise yourself with the product prior to
assembly. Carefully read the following assembly
instructions and safety advice. In the event of incor-
rect installation, all warranty claims – particularly
in relation to subsequent damage – are excluded.
CAUTION! Before you start installation turn
off the water supply at the mains. Otherwise
injuries and / or property damage may occur.
CAUTION! Do not twist the connection hoses
10 or place them under tension.
Note: this step requires a cross-tip screwdriver,
a slotted screwdriver and a spanner SW 9 mm.
Follow these steps:
Place the fitting base seal 2 inside the groove
on the base of the fitting 1 .
Screw the two flexible connection hoses 10
hand tight into the designated female threads
inside the fitting body
1 (see Fig. C1).
Note: the two flexible connection hoses 10
are identical.
The flexible connection hose 10 being screwed
into the left borehole on the fitting body will be
the hot water hose, the flexible connection
hose
10 being screwed into the right borehole
will be the cold water hose.
CAUTION! Be sure to only tighten the flexible
connection hoses 10 hand tight (see Fig. B).
Do not use pliers or a wrench. Otherwise the
product could be damaged.
Remove the securing nuts 9 from the thread
bolts 8 , then using a slotted screwdriver
screw the thread bolts 8 all the way into the