EverFocus EQ550 - Manual (Page 12)

- 11 -
6. USER SETUP
6.1 LENS
1. When the SETUP menu is displayed on the screen, please direct the arrow to point to
“LENS” by using the UP and DOWN buttons.
2. Please select the type of the lens you would like to use by pressing the LEFT or RIGHT
button.
3. Please press the SETUP button if you would like to return to the previous menu.
6.2 SHUTTER
Auto or manual control can be selected.
1. When the SETUP menu is displayed on the screen, please direct the arrow to point to
“SHUTTER” by using the DOWN button.
2. Select the shutter mode by pressing the LEFT or RIGHT button.
Ö FLK: Please select “FLK” mode when flickering occurs on the screen, because of an
irregular balance between illumination and frequency. NTSC model: 1/100, PAL
model: 1/120.
SETUP
> LENS DC
<┘
SHUTTER ___
WHITE BAL. ATW
BACKLIGHT OFF
AGC MIDDLE
DNR LOW
SENS-UP AUTO
<┘
SPECIAL <┘
EXIT
NOTE:
○
1 When using an auto iris lens, the setting of the auto iris lens selection switch, located on
the back of the camera, must be on DC or MANUAL depending on the type of the lens
which is being used.
○
2 The brightness of the screen can be adjusted on DC mode in LENS LEVEL. The level
can be adjusted from 1 to 70.
LENS
LEVEL |+++++++++| 20