Emotiva UPA-7 - Manual (Page 11)

UPA-7 Rear Panel Layout
1. RCA Audio Inputs - These inputs are for signal input on the UPA-7. Simply connect the appropriate
input to your preamplifier/processor or other preamp level audio device.
2. Master Power Switch - This rocker switch provides the master power for the UPA-7. After it is in the
ON position, the amplifier can be turned on manually from the front panel switch or automatically with the
trigger input via 3.5mm input jack.
3. Remote Trigger Input - This 3.5mm jack accepts a 5-12 volt input for remote activation of the UPA-7.
This mates directly with the Emotiva processor trigger out. If building your own cable, center is positive
and outer shield is negative.
4. Speaker Outputs (5 way Binding Posts) - These are the speaker outputs. The 5 way binding posts
accept stripped speaker wire, banana plugs (single or dual), or spade connectors. Be sure to observe
correct polarity when connecting speakers and be sure that the wires do not touch between positive and
negative terminals.
5. Power Receptacle - This is a standard IEC 2 prong power receptacle. It is advised that this amplifier
have a direct connection to a wall outlet. Do not plug into a “power strip”.
Note: Potentially lethal voltages present! Never connect, disconnect or modify speaker
wiring with the amplifier turned on.
11