Sealey SA0615KIT - Manual (Page 7)

NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
ImpoRtAnt: no liability is accepted for incorrect use of this product.
WARRAntY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
InFoRmAtIon: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
sole uk Distributor, sealey group,
Kempson Way, suffolk Business Park ,
Bury st. edmunds, suffolk,
IP32 7ar
www.sealey.co.uk
Web
email
environmental protection.
recycle unwanted materials instead of disposing of them as waste. all tools, accessories and
packaging should be sorted, taken to a recycle centre and disposed of in a manner
which is compatible with the environment.
When the product is no longer required, it must be disposed of in an
environmentally protective way.
11. nAIl/stAple gun tRouBleshootIng
FAult cAuse RemeDY
1) air leak near top of tool or in trigger area. o-ring in trigger valve damaged.
trigger valve head is damaged.
trigger valve stem or seal damaged.
check and replace.
2) air leak near bottom of tool. loose screws.
Worn or damaged o-rings or bumper.
tighten screws.
check and replace o-rings or bumper.
3) air leak between body and cylinder cap. loose screws.
Worn or damaged o-rings or seals.
tighten screws.
check and replace o-rings or seal.
4) Blade driving fastener too deep. Worn or damaged bumper.
air pressure is too high.
check / replace bumper.
adjust air pressure.
5) Gun operates sluggishly, cannot drive fastener. Inadequate air supply / lubrication.
Worn or damaged o-rings or seals.
exhaust port in cylinder head blocked.
check air supply/ drop oil into air inlet.
check and replace o-rings or seals.
replace damaged internal parts.
6) tool jams. Incorrect or damaged fasteners.
damaged or worn driver guide.
magazine or nose screw loose.
magazine is dirty.
. use correct/undamaged fasteners.
check / replace driver guide.
tighten magazine / screw.
clean magazine.
7) tool skips fasteners. Worn bumper or damaged spring.
dirt in front plate.
dirt or damaged fasteners in magazine.
Worn or dry o-ring on piston.
cylinder cover seal leaking.
replace bumper or pusher spring.
clean drive channel on front plate.
check / clean magazine.
replace / lubricate o-ring.
replace sealing washer.
Original Language Version
sa0615KIt Issue: 2- 20/02/12