Eltax AVR-800 - Manual (Page 25)

Test Tone
24
Press t he TEST TONE but t on in DTS, Dolby Digit al or
Surround mode.
The test tone is emitted from each speakerin the following
order at 2-second intervals.
1
< Pro LogicI I mode.
< 3-STEREO mode.
Adjust the volume of center and rear speakers so that the
test tone from each speakers sounds same.
Select a speaker by pressing the LEVEL SELECT button, and
adjust the level by pressing the ADJUST button( / ), or
adjust the channel level directly by pressing the remote
contral unit (Center, Rear, Subwoofer, Back : /
).
< The level of rear, cent er, subwoofer and Back can be
adjusted in 1 dB steps from -10 dB to + 10 dB.
When the setting is finished, press the TEST TONE button to
stop the test tone.
Note :
< I f certain speakers are not being used, (for example, no
center speaker) the noise sequencer will automatically skip
over that channel.
< Press the LEVEL SELECT, ADJUST button for more than 5
seconds to reset the level to its original setting.
4
3
The test tone function is useful to adjust the relative volume
between speakers in DTS, DOLBY DI GI TAL or DOLBY PRO
LOGICII mode.
Once t he balance is set , you don't have t o change t he
balance as long as the speakers aren't moved.
CNT
BC
(Back center)
FL(Front Left) CNT(Center) FR(Front Right)
FL(Front Left) CNT(Center)
FR(Front Right)
Adjust the master volume to the normal listening level. 2
ADJUST LEVEL
SELECT
1
4
2
3
1
4 2 3
1 4
2
Balancing relative volume between speakers