Eton G3 - Manual (Page 10)

18
GLOBE TRAVELER G3 OWNER’S MANUAL
19
GLOBE TRAVELER G3 OWNER’S MANUAL
8. Skip this step if you want to use the last frequency tuned to wake to.
While the page number is in the display press one of the F1-7 buttons to
select the memory location on the selected page of the frequency you
want to wake to (the square flashes).
9. Press the PAGE/TIME button to finish the set-up.
For an alarm to turn the radio on, it must be activated. To activate the
alarm to be used, turn off the G3 and press the appropriate alarm button,
F1-4. This causes the timer activation symbol to appear in the upper left
corner of the display, activating the selected alarm. To deactivate the alarm,
press the appropriate F1-4 button, causing the alarm activation symbol to
disappear.
The light illuminates the display and buttons. Turn it on and off by pressing
the LIGHT button. When using batteries the light stays on for about 6
seconds; when using an AC adapter it stays on indefinitely or until turned
off.
The external antenna socket is used to connect the G3 to advanced
performance shortwave antennas using a 50 or 75-Ohm coaxial cable
feed-line.
When listening to FM stations, stereo/mono is selected automatically
depending on the quality of the audio from the station.
This socket provides an industry standard, fixed level audio input/output
source for safely routing the G3’s audio to the line-in socket of a stereo
system or recording device, or playing an audio device, such as MP3, through
the G3.
To route a line-in source into the G3, turn it off, attach a double 1/8 inch
(3.5mm) stereo cord to the G3’s LINE –IN/OUT socket and to the output of
the other system. Press the G3’s LINE-IN button, labeled
TZ/LINE-IN.
To route the audio output of your G3 to another device, turn it on, plug a
1/8 inch (3.5mm) stereo cord into the G3’s LINE-IN/OUT socket and into
the other device’s LINE-IN socket. Follow your external device’s line-input/
output instructions.
Plug them into the earphone socket on the left side of the radio.
Turn the volume down before wearing the earphones, then turn up
the volume to your liking.
Pull the folding stand from the rear of the G3, allowing viewing at a
comfortable angle.
The reset button is located inside the small hole labeled RESET on the right
front of the radio. If the G3 operates erratically, poke a paper clip into the
reset hole to reset its microprocessor. This does not erase memory, but
does reset the clock to 12:00.
SETTING ALARMS 1 THROUGH 4
continued
ACTIVATING AND DEACTIVATING THE ALARMS
USING THE LIGHT
EXTERNAL ANTENNA SOCKET
LINE-IN/OUT SOCKET
REAR FOLDING STAND
RESET BUTTON
FM STEREO/MONO SELECTION
EARPHONE SOCKET AND USING EARPHONES
(not included)