Sealey AK436 User Manual
Page 2
fig.1
fig.4
fig.3
fig.2
1
2
1
H
2. INTRODUCTION & OPERATION
2.1. INTRODUCTION
Weatherproof composite spotlight with swivel handle feature allowing pistol grip or carry handle operation. Integral foot doubles as carry
handle when used in pistol grip mode. Ø130mm Lens with halogen bulb produces 3-million candle power of intense white light, suitable for a
variety of -industrial, domestic and leisure applications. Supplied with sealed 6Volt battery, in-vehicle charger and 9Volt battery charger pack.
2.2. OPERATION
WARNING! Ensure you read and understand safety instructions before use.
Reminder: These spotlights are designed for intermittent use only. Continuous use may damage the unit.
1. Charge the battery before use.
IMPORTANT: Turn off spotlight whilst charging. Failure to do so will damage the charger plug /
vehicle plug.
2. Turn spotlight ‘On’ and ‘Off’ by pressing the switch on the main body.
3. To use as shown in fig.1, press locking button (fig.1.1) and rotate the handle (fig.1.2) to grip position. fig.2 shows the arrangement for
standing the spotlight on a surface, using the adjustable support.
2.3. BATTERY CHARGING
IMPORTANT WARRANTY INFORMATION: The battery pack fitted to this cordless tool is considered to be a consumable item and its ability to
accept charge will reduce over time. We will warranty it against mechanical and electrical defect for a period of one year - this does not cover
fair wear and tear. If the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these
circumstances we will not replace the battery pack even if it is less than one year old.
WARNING! Ensure you read, understand and apply safety instructions relating to the battery and charger before use.
2.3.1.
Charger plug
1. Ensure the spotlight is turned ‘Off’, then plug the charger adaptor (fig.3) into the jack inlet on the spotlight body (fig.2.1) and stand the
spotlight in a safe location ready to charge.
2. Plug charger into the mains supply.
3. Allow approximately 15 hours for the battery to charge.
When fully charged, switch off the mains supply and unplug the charger from the mains supply. Remove the charger adaptor (fig.3) from
the spotlight and seal the jack inlet. The spotlight is now ready to use.
4. Store the charger in a safe, dry location.
Note: a) A fully charged battery will last for approximately 50 minutes.
b) Do not let the battery fully discharge.
2.3.2.
Vehicle plug
Note: The battery will also charge from the 12V vehicle socket using the 12V DC charging cord. Therefore this method is recommended
for emergencies or for a quick charge only, This method should not be used for long-term charging, Charge the spotlight for no
longer than 2 hours.
1. Ensure spotlight is turned ‘Off’ and then plug the 12 volt vehicle plug adaptor (fig.4.) into the jack inlet on the spotlight body (fig.2.1)
and stand the spotlight in a safe location ready to charge.
2. Insert the adaptor’s plug into the vehicle’s accessory socket. Allow battery to charge (see note above).
3. When charged, unplug the adaptor from the vehicle’s socket and also from the spotlight
before turning the spotlight on.
4. Store the adaptor in a safe, dry location.
Note: Charging the spotlight from a 12 volt vehicle socket will drain the vehicle battery, unless the engine is running.
Original Language Version
AK436.V3 Issue: 2 - 18/01/12