Ecom Instruments ECOM-EF24F2G - Manual (Page 39)

5 Management Software Guide
31
ECOM ES24F2G the Gigabit Ethernet Switch User’s Manual V1.0
Pull down Menus
There are totally of 4 pull down menus at the top of the screen. We will explain the function of each
one.
System menu
Save and Load Configuration
You can save or load the configuration to a file.
To save a file, do one of the following:
In the menu, click System | Save Configuration .
Note: The configuration file are named by the switch’s MAC address.
To load a file, do one of the following:
In the menu, click System | Load Configuration .
In the Open File dialog box, select a “.rrcp” file and click Load.
In the Setting Active Switch dialog box, select a switch you want to set, and click OK.
Options menu
Hello polling
The Management Application send hello packet to switches in the network, and this function is used
to set the generation interval of hello control frame. To reduce unnecessary control frame traffic, a
value of 2 seconds is recommended.
Counter polling
The Management Application send packet to read the counter registers, and this function is used to
set the generation interval of these packets. To reduce unnecessary control frame traffic, a value of 6
seconds is recommended.
efficiency.
Auto Detect and Reload
This function allows the program to automatically load the configuration file from the PC and
restore to the switch. . Please check the “load application file automatically” to activate. The use of
this function is not recommended for the switch as its settings are kept inside the switch’s
non-volatile flash memory.