Sealey TP6905 User Manual
Tp6905, Tp6906, Fig.2 fig.1
InstructIons for:
VACUUM OIL/FLUID EXTRACTORS
MANUAL OPERATION 6 & 18LTR
models:
TP6905 & TP6906
thank you for purchasing a sealey product. manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1.
SAFETY INSTRUCTIONS
WARNING! DO NOT allow uncontrolled discharge of fluids thus
polluting the environment.
use only to extract engine or transmission oils, or similar non-
corrosive fluids. unit may also be used for the transfer of water.
do not use to extract hazardous or harmful chemicals, solvents,
petrol, diesel, kerosene, alkaline or acids. If by chance such fluids
are used in the unit, it must be immediately drained and
thoroughly cleaned. use with prohibited fluids will invalidate your
warranty.
do not store fluids in the extractor’s tank. After extracting
fluid, it must be emptied into an approved receptacle as soon as
possible.
do not dismantle, tamper or adapt the extractor for any purpose
other than for which it is designed.
do not store in areas of high temperature, direct sunlight, rain or
snow.
do not connect these units to an air compressor.
do not dismantle these units.
do not leave these units in a pressurised state.
WARNING! When the extractor's tank contains liquid that is
under pressure do not remove or insert the extension tube
connector into the inlet/outlet fitting as this may result in a
sudden discharge of liquid that could be dangerous.
Always press the pressure relief button before connecting or
disconnecting the extension tube.
WARNING! Ensure Health & Safety, local authority, and general
workshop practice regulations are strictly adhered to when using this
equipment.
Important! Ensure that you wear protective clothing, gloves,
goggles, face mask as appropriate for the fluid being extracted.
Keep the extractor clean and maintain it in good condition (use an
authorised service agent).
replace or repair damaged parts. Use genuine parts only.
Unauthorised parts may be dangerous and will invalidate the
warranty.
check extractor connections and fittings before use. When the
unit is in use check that there are no leaks.
ensure that the extractor’s tank capacity exceeds the amount of
fluid to be collected.
ensure that the end of the suction tube is fully submerged in the
fluid before operating.
When not in use store in a safe, dry, childproof area.
Keep the work area clean, uncluttered and ensure there is
adequate lighting.
maintain correct balance and footing. ensure the floor is not slippery
and wear non-slip shoes.
Keep children and unauthorised persons away from the working area.
dispose of waste fluids in accordance with local authority
regulations.
tP6905,tP6906
Issue no:1 17/10/08
model no:
TP6905
model no:
TP6906
fig.2
fig.1