Sealey AK4561D - Manual (Page 2)

AK4561D Issue no: 1 - 14/11/08
3.1 Trolley Assembly (fig.1)
3.1.1 Attach the two castor wheels (10) to the base plate (16) using washers (9)
and nuts (8).
3.1.2 Turn the base plate upside down and attach the axles (14) to the base plate
using hex bolts (15) and then slide the wheels (13) onto the axles and
secure using washers (12) and hex bolts (11). Turn the base plate over so
that it is now supported on its wheels.
3.1.3 Slide the two pump support brackets (4) onto the handle (3) and attach
them using hex grub screws (5).
3.1.4 Slide the accessory support (7) onto the other side of the handle and attach
using hex grub screw (5), insert stopper (6) into the top of the accessory
support.
3.1.5 Slide the handle assembly into the base plate until it bottoms out on the
stops and secure with two hex grub screws (17).
3.1.6 Slide the drum holder support into the handle and secure using knob (1).
3.1.7 Adjust the pump support brackets, so that they fully support the pump
assembly and check all nuts are tight.
3.2 Pump and Air Regulator/Lubricator Assembly
3.2.1 Apply a small amount of liquid thread sealant onto the threads of the air
inlet of the pump and attach the air regulator/lubricator (fig.2).
❐ WARNING! DO NOT allow thread sealant to enter the pump.
3.2.2 Attach the outlet pipe to the male outlet thread on the pump and attach the
male threaded end of the pipe to the Digital Hose End Meter.
3.2.3 Attach the nozzle valve pipe assembly to the outlet of the Digital Hose End
Meter.
❐ WARNING! DO NOT overtighten the swivel connections.
3.2.4 Slide the locking nut, locking ring and the barrel nut onto the pick up probe
of the pump (fig.3), screw the locking nut onto the barrel nut to lock the
assembly to the pick up probe.
3.2.5 Insert the pump assembly into the support brackets on the trolley and hang
the meter onto the accesssory support bracket.
fig.1
fig.2
A
BC
fig.3
Locking Nut
Lock Ring
Barrel Nut
3. AssemBly