Sealey AP6500 - Manual (Page 3)

4.9 See Fig.11. Lay a shelf 'D' in between the step beams at
each level created (See lower detail in Fig.11).
4.8 See Fig.10. Build one shelf support in the top half of the
frame and one shelf support in the bottom half of the frame
at the heights required. Ensure that the beams are the
right way up. Tap the beams at either end to ensure that the
tabs are properly seated into the slots.
4.7 See Fig.9. now stabilise the top part of the frame by adding
two long step beams (B) to make a shelf support at the top of
the frame as shown in Fig.9. Ensure that the beams are the
right way up. Tap the beams at either end to ensure that the
tabs are properly seated into the slots.
Fig.9
Fig.10
Fig.11
AP6500 Issue: 1 - 05/06/09