Sealey GSS3030 User Manual
Page 8
7. ASSEMbLY
7.1 ASSEMbLE THE REAR WALL PANELS:
7.1.1 You will find it easier to assemble the shed using sawhorses with timber studding attached as indicated below or
alternatively a trestle table. (Any timber studding used will need to be the same length as the shed i.e. 3mtr).
Trestles are available from your Sealey Dealer, Part No. FDT3. Attach the studding to trestles with equal
overhang using nylon cable ties or similar ‘safe’ method.
7.1.2 Place 2 x 9S sheeting panels and 2 x 9M sheeting panels onto your work table and join them together
with self tapping screws as indicated in the diagram below.
7.1.3 Now fit 27I, 27H top channels and 27C & 27D bottom channels to the sheeting by tapping them into place as
shown in diagram A or sliding them onto the panels as shown in diagram B. Note that the smaller lip on the
channels should always be facing to the outside face of the panels. This is to prevent water ingress. Ensure that
27I and 27H are used as the top edging to the panel as indicated in diagrams A & B.
© Jack Sealey Limited
Original Language Version
GSS3030 Issue No.1 13/08/12