Livarno ENERGY-SAVING SPOTLIGHT - Manual (Page 31)

31 GB/MT
Safety advice
Safety advice
The right to claim under the warranty shall be ren-
dered invalid in respect of damage caused by the
non-observance of these operating instructions! No
liability is accepted for consequent damage! No li-
ability is accepted for damage to property or persons
caused by improper handling or non-observance of
the safety advice!
RISK OF EXPLOSION! Do not
operate the lamp in potentially ex-
plosive environments in which there
are inflammable vapours, gases or dusts.
Do not allow the lamp or the packaging mate-
rials to lie around unattended. Plastic film or
bags, styrofoamm etc. can turn into dangerous
toys for children.
Do not expose the lamp to direct sunlight, rain,
snow or ice. Otherwise damage to the product
can result.
The light can be mounted on all surfaces officially
classified as being of “normal flammability”.
Avoid danger to life from
electric shock
Electrical installation must be performed by a
qualified electrician or a person authorised to
perform electrical installations.
Never use your lamp if you discover that it is
damaged in any way.
In the event of damage, repairs or other problems
with the lamp, please contact the Service Centre
or an electrician.
Never let the lamp come into contact with water
or other liquids.
Never open any of the electrical equipment or
insert any objects into it. This may result in the
danger of death from electric shock.
Before installation, switch off the electrical circuit
at the circuit breaker box or remove the fuse
from the fuse box.
Before assembly, ensure that the mains voltage
available corresponds to the operating voltage
necessary of the light (220–240 V∼).
Avoid fire hazards and risk
of injury
RISK OF INJURY! Check every bulb and
lampshade for damage immediately upon un-
packing. Do not fit the light if the bulbs and / or
lampshades are faulty. If they are, contact the
service point for a replacement.
RISK OF ELECTRIC SHOCK! DANGER
OF DAMAGE TO PROPERTY! RISK OF
INJURY! Please ensure that you do not drill
into any electrical wiring, gas or water pipes in
the wall. If necessary, carry out checks with a
wire, pipe and stud detector before you drill
into a wall.
RISK OF INJURY FROM BURNS! Ensure
the lamp has been switched off and allowed to
cool before you touch it. Bulbs give off a lot of
heat around the top of the lamp.
1 m
FIRE HAZARD! Fit the light so that
it is at least 1 m away from the mate-
rial illuminated. Fire can result from
the development of too much heat.
Any broken glass must be replaced
before any further use is made of
the lamp.
Allow the lamp to cool for at least 15 minutes
before replacing a defective bulb.
Replace defective bulbs immediately. Before
replacing the bulb, always remove the fuse or
switch the automatic cutout off.
Always install the lamp above head height.
Failure to observe this advice could result in
injury.
Working safely
Always use a 220 – 240 Volt ∼ spiral shaped
bulb suitable for an E27 fitting and a maximum
rated output of 23 watt.
Make careful preparations for the assembly
and take sufficient time. Clearly lay out all
components and any additional tools or materi-
als that might be required so that they are
readily to hand.
89559_livx_Energiesparstrahler_Bewegungsmelder_Content_LB5.indd 31 22.04.13 08:26