Livarno Z31669 - Manual (Page 5)

5 GB
avoid the danger of
death from electric
shock!
Ensure that a qualified electrician,
or a person trained to carry out
electrical installations, performs
the electrical installation.
Always check the light, power
supply, and mains cable for
damage before plugging it in.
Never use the light if it shows
any signs of damage.
Prior to installation, remove the
fuse or switch off the circuit
breaker (0 setting) in the fuse
box.
Before assembly, ensure that
the available mains voltage
corresponds to the operating
voltage necessary for the light
(230 V ∼).
Ensure that the light does not
come into contact with water
or other liquids under any
circumstances.
Do not install the light on damp
or conductive surfaces.
Prevent fire and
injury hazards
rISk of InJUrY! Check
each bulb and lamp glass for
damage immediately after un-
packing. Do not fit the light if
the bulbs and / or lampshades
are faulty.
rISk of BUrnS! Ensure
that the light has been switched
off and has cooled before
touching it, to avoid burn inju-
ries. Lamps develop a lot of
heat in the area of the lamp
head.
0.5 m
fIre HaZarD! Fit
the light so that it is at
least 0.5 m away from the
material to be illuminated.
caUTIon! rISk
of fIre! Under no
circumstances should you cover
the halogen recessed lights
with heat insulating material
or similar.
Make sure you have adequate
ventilation. The maximum tem-
perature of 90 °C in the area
of fitting may not be exceeded.
Only use the recessed light set
with the accessories that were
delivered with it! Do not con-
nect recessed light sets in a row!
Do not use bulbs with
cool beam reflectors.