Livarno Z31669 - Manual (Page 7)

7 GB
circuit. To do so, remove the fuse or switch off
the circuit breaker in the fuse box (0 position).
Allow the light to cool completely.
Loosen the spring ring 3 from the lamp
housing 1 .
Withdraw the defective bulb 2 and bulb
holder 8 a little from the lamp housing.
Use a clean, lint-free cloth to replace a bulb.
Never touch the glass of the halogen lamp
with bare fingers, even when cold, as the
glass can become matt through contact with
the sweat on the skin. In doubt, use a little bit
of alcohol to clean the surface of the glass.
Keep hold of the fitting and turn the bulb
with a ¼ turn anti-clockwise out of the fitting.
Use only 230 V ~bulbs with a GU10 socket
and a maximum power of 40 watts.
Do not use cool beam bulbs.
Risk of overheating!
Fit the new bulb. Insert the bulb carefully
into the socket and tighten it with a ¼ turn
in a clockwise direction.
Secure the bulb to the lamp housing, using
the spring ring. Check for correct fitting (see
Fig. A).
cleaning and care
caUTIon! rISk of elecTrIc
SHock! Disconnect the light from
the mains circuit before cleaning. To
do so, remove the fuse or switch off the circuit
breaker in the fuse box (0 position).
caUTIon! rISk of elecTrIc
SHock! For reasons of electrical
safety, never clean the light with water
or other fluids, or immerse it in water. Only use
a dry, lint-free cloth for cleaning.
Disposal
The packaging is made of environ-
mentally friendly materials, which may
be disposed through your local recy-
cling facilities.
Contact your local authorities for information on
how to dispose of the product at the end of
product life.
Never dispose of the product and
the bulb in your regular household
rubbish.
Dispose of the product and light bulb through
an authorised waste management company or
your municipal disposal facilities.
Observe the applicable regulations. When in
doubt please contact your waste disposal centre.