Livarno Z31669 - Manual (Page 6)

6 GB
Proper procedure
and handling!
Install the light so that it is pro-
tected from moisture, dirt and
excessive heating. Avoid fitting
the lights in bathrooms or simi-
lar rooms.
Use only 230 V ∼ bulbs with a
GU10 socket and a maximum
power of 40 watt.
The distance between two
recessed light spots must be at
least 20 cm. The fitting area
over the lamp fitting must be
at least 10 cm and to the side
at least 10 cm (see Fig. H).
Prior to installation
Important: The electrical connection must be
established by a qualified electrician or a person
trained to perform electrical installations. This
person must be familiar with the properties of
the light and the connection regulations. The
cables leading to the lights must be according
to the local regulations.
Before installation, ensure that the circuit to which
the light will be connected, is not live. To do so,
remove the fuse or switch off the circuit breaker
at the fuse box. To check the power is off, use a
circuit tester.
Start-up
Using a hollow drill (ø 68 mm), drill the 6 holes
at the installation point. Take care to observe
the minimum distance between two recessed
light spots. This must be at least 20 cm.
Insert the retaining springs 4 into the spot-
lights (see Fig. B and C). The small lug of
the retaining springs must lie on the inside
of the housing of the lamp
1 so that the
retaining springs are tensioned.
Open the mains socket 9 by unscrewing
the cover 5 with a screwdriver (see Fig. D).
Undo the cable holder 6 using a screw-
driver.
Install the power lines into the tubes 10 and
then connect the power line to the terminal
block 7 (see Fig. D) and tighten the cable
holder using a screwdriver.
Hint: Make sure the power lines are com-
pletely covered by the tubes inside the
mains socket.
Close the mains socket, by tightening the
cover using a screwdriver.
Place the fitting 8 of the mains socket onto
the bulb 2 including the lamp housing and
turn the bulb until tight with a ¼ turn in a
clockwise direction (see Fig. E).
Before fitting the recessed light spot, remove
possibly present insulating material from the
vicinity of the mains socket and the spots.
Fold the two retaining springs upwards and
guide the recessed light spots with the con-
nection cable into the installation opening
(see Fig. F).
After you have pushed the spot into the open-
ing, the retaining springs unfold and fix the
recessed spot in place (see Fig. G).
Proceed in the same way with the other five
recessed light spots.
The recessed light spots are now ready for
use.
Now switch the power back on.
replacing a bulb
caUTIon! rISk of elecTrIc
SHock! To replace the bulb, first
disconnect the light from the mains