Silvercrest TWINTALKER 4810 - Manual (Page 15)

Twintalker 4810 15
Twintalker 4810
ENGLISH
13.10.3 Scanning for a DCS code
Once there is a transmission on the channel, the DCS code (if used) will be detected and
displayed.
13.11 Call Tones
A call tone alerts others that you want to start talking.
13.11.1 Setting the Call Tone
The Twintalker 4810 has 15 call tones.
13.11.2 Sending a call Tone
Press the
button briefly. The call tone will be transmitted on the set channel.
13.12 Roger Beep On/Off
After the -button is released, the unit will send out a roger beep to confirm that you have
stopped talking.
To set the Roger Beep.
• Press the
- button nine times. ‘rO’ will be displayed.
• Press to enable (ON) or to disable the Roger-Beep (OF).
• Press the PTT - button to confirm your selection and return to the
standby mode.
• Press the -button seven times : "SC" and "DCS 00"
flashes on the display for the selected radio channel.
• Press the -button or the -button to start the
DCS scan.
• Press the - button eight times, “CA” is displayed
and the current call tone is flashing.
• Press the - button or the - button to change to
another Call Tone.
• Press the PTT - button to confirm and return to stand-by
mode.
5
9 6
If you press the PTT button while listening to a found DCS code, the
PMR will go back in stand-by mode on the channel with the DCS code.
11
5
9
6
11
4
PTT
5
11