Silvercrest TWINTALKER 4810 - Manual (Page 16)

16 Twintalker 4810
Twintalker 4810
13.13 Key-Tone On/Off
When a button is pressed, the unit will beep briefly.
To set the key-tone.
• Press
ten times. ‘tO’ will be displayed.
• Press to enable (ON) or disable the Key Tones (OF).
• Press the PTT - button to confirm your selection and return to the.
standby mode.
13.14 Dual Channel Monitor function
In stand-by, the PMR is set on one channel with CTCSS/DCS code. The PMR will only
receive signals transmitted on that channel with the CTCSS/DCS code.
Dual Channel Monitor (DCM) allows you to monitor a second channel with CTCSS/DCS
code.
When the Dual Channel Monitor function is activated, the PMR will switch sequentially
between the standby channel + CTCSS/DCS code and the Dual Channel + CTCSS/DCS
code.
13.15 Button Lock
• Press the -button eleven times,” DCM OF" will flash
on the display.
• Press the -button or the -button to change the
channel.
• Press the -button to confirm the channel selection
and go to CTCSS selection. (Press the -button
again to go to DCS selection)
• Press the -button or the -button to change the
CTCSS code or DCS code.
• Press the PTT-button to confirm and return to stand-by
mode.
• To disable the function select "OF" when selecting the DCM
channel.
• Press and hold the -button for three seconds to
activate the Button lock mode. The button lock icon is
displayed on the LCD Screen.
• Press and hold the -button again for three seconds
deactivate button lock
11
5
9 6
5
5
9 6
11
5
5
The PTT-button , the -button and the -button will still be
functional when the Button Lock is activated.
11
4 10