Silvercrest TWINTALKER 4810 - Manual (Page 8)

8 Twintalker 4810
Twintalker 4810
9 Getting started
9.1 Installing/Removing the Belt Clip
1. To remove the belt clip from the unit, push the
belt clip (B) towards the antenna, while pulling
the clip tab (A).
2. When re-installing the belt clip, a click
indicates the belt clip is locked into position.
9.2 Battery Installation
1. Remove the belt clip (See chapter “9.1 Installing/Removing the Belt Clip”).
2. Lift the battery door by gently pushing the door clip (C) using your finger nail.
3. Install the NiMh batteries. Make sure that the polarity of the NiMh batteries is correct.
4. Close the battery door.
5. Re-install the belt clip.
A
B
C