Silvercrest SLB 450 A2 - Manual (Page 18)

16
Troubleshooting
SLB 450 A2
GB
Malfunction causes and remedies
The following table will help with localising and eliminating minor malfunctions:
Defect Possible cause Solution
Appliance does
not switch on.
The plug is not inserted.
Insert the plug into a mains power
socket.
Mains power socket does
not supply any power.
Check the fuses.
The remote control 9
was not directed at the
appliance.
On activation, aim the remote control
at the pump
.
The battery in the remote
control is empty. Insert a new battery into the remote
control.
Appliance does not
let itself be switched
off .
The battery in the remote
control is empty. Insert a new battery into the remote
control.
Function button 3 not
pressed often enough.
Press the function button repeatedly
until the appliance switches off .
There are no air
bubbles exiting the
air-bubble mat.
Appliance not switched on. Switch the appliance on.
Air hose 8 not properly
connected.
Properly connect/lock the air hose
to the air-bubble mat
6 and to the
pump .
Air-bubble mat does
not adhere to the
fl oor of the bathtub.
Suction cups of the air-
bubble mat are not clinging
fi rmly to the fl oor of the
bath.
Moisten the suction caps on the air-
bubble mat and then press it fi rmly
onto the bottom of the bath tub.
Soap, shampoo or hair
remnants prevent fi rm
suction to the bottom of
the bath tub.
Remove the soap, shampoo or hair
remnants/rinse the bath tub out before
pressing the air-bubble mat down.
Appliance stops
automatically. Cooling time after
operation too short.
After use, allow the pump to cool
for at least 10 minutes and fi rst then
restart it if still needed.
NOTICE
If you cannot solve the problem with the aforementioned methods, please ►
contact Customer Service.