Cutting hair – Silvercrest SHBS 1000 A1 User Manual
Page 74
74 GB/MT
Use
Q
Cutting hair
Tip: Start with a cutting length comb attachment with a longer cutting
length than is finally required, then proceed in stages until you achieve
the desired length.
Cutting length comb attachments
6
:
j
Select the cutting length comb attachment
6
(4 - 6 mm / 7 - 9 mm /
10 - 12 mm / 16 - 18 mm / 22 - 24 mm / 28 - 30 mm) to suit the desired
cutting length.
j
Push the selected cutting length comb attachment
6
from the rear
on to the blade set
1
. Ensure that the two pins on the attachment
engage properly into the recesses in the sides of cutter head mount.
Note: By adjusting the setting of the sliding switch
2
you can
finely graduate the desired cutting length of the cutting length comb
attachments
6
. If you select the cutting length comb attachment
6
for a hair length of 22 - 24 mm and would like to cut your hair to
22 mm, then slide the sliding switch
2
for the fine adjustment of
the cutting length as far as it will go upwards (0.5 mm). Stepping
the fine adjustment setting switch downwards increases the cutting
length to 22.7 mm (with a fine adjustment of 1.2 mm); to 23.4 mm
(with a fine adjustment of 1.9 mm) or to 24 mm (with a fine adjust-
ment of 2.5 mm).
Cutting length comb
attachment 6 (mm)
Cutting lengths*
with cutting length fine adjustment (mm)
0.5
1.2
1.9
2.5
4 - 6
4.0
4.7
5.4
6.0
7 - 9
7.0
7.7
8.4
9.0
10 - 12
10.0
10.7
11.4
12.0
16 - 18
16.0
16.7
17.4
18.0