Cutting without an attachment – Silvercrest SHBS 1000 A1 User Manual
Page 75
75
GB/MT
Use
Cutting length comb
attachment 6 (mm)
Cutting lengths*
with cutting length fine adjustment (mm)
0.5
1.2
1.9
2.5
22 - 24
22.0
22.7
23.4
24.0
28 - 30
28.0
28.7
29.4
30.0
* Please note that the actual cutting lengths may deviate from the
cutting lengths given here, depending on the cutting angle.
j
Always cut off small amounts at a time.
j
Guide the hair and beard clippers slowly through the hair.
j
Hold the device so that the selected cutting length comb attachment
6
is always lying as flat on the scalp as possible.
j
Always cut from the neck towards the top of the scalp or from the
forehead and temples upwards towards the centre of the scalp.
Q
Cutting without an attachment
CAUTION! DANGER OF INJURY!
The cutter head is very sharp!
Without a cutting length comb attachment
6
in place, the device can
cut hair to a length of between 0.5 mm and 2.5 mm. Slide the sliding
switch
2
to finely adjust the cutting length to the desired value.
Note: By varying how and at what angle you hold the hair clippers,
you can depart from the cutting lengths indicated in these instructions
for use or marked on the attachment / device.