Silvercrest SHBS 600 A1 - Manual (Page 55)

55 GB/MT
Use
Note: Depending on how you hold the appliance and the angle this results in, the cutting
lengths may deviate from those mentioned in these instructions or the lengths marked on the
attachments.
Note: In order to improve cutting performance, place a drop of oil on the shaver head
2 .
This is particularly recommendable after cleaning. Wipe excess oil away with a cloth (see also
section called “Cleaning and care”).
Q
Thinning out hair
This tool reduces the volume of the hair to produce a modern, straggly look without altering
the length of the hair.
j In order to thin the hair out, push the slide button 3 to the left; the thinning function 2
integrated in the trimmer head will then extend upwards.
Q Trimming and cutting your beard
j Set the desired cutting length depending on how long you want your beard to be. Now
gradually trim your beard.
Without a comb attachment 1 , the beard can be cut to a length shorter than 4 mm.
Q
Cutting without an attachment
CAUTION! RISK OF INJURY!
THE SHAVER HEAD
2 IS VERY SHARP!
Remove the comb attachment 1 (see Fig. A-C):
j Turn the appliance round so you can see its back and push the comb attachment 1
upwards using the slide 9 .
j Using your thumb and index finger and with moderate force, push the comb attachment 1
carefully upwards and over the lateral locking pins. The comb attachment 1 will be
released from the comb attachment fastening 4 .
j Remove the comb attachment 1 .
Without a comb attachment 1 , the hair can be evenly cut to a length of 1 - 2 mm.