Silvercrest STG 70 B2 - Manual (Page 9)

7 GB
3. The upper door hinge is
located on the front side at
the top right. Unscrew the
three screws.
4. Remove the upper door
hinge with the small plas-
tic ring.
5. Remove the plastic sleeve
(bearing) at the top right
from the door.
6. Unscrew the two screws at the top left and then screw
them into the outer holes on the right-hand side.
7. Open the door slightly and carefully lift it off. Place the
door with its inside on the freezer, so that you can see the
lower edge.
8. Unscrew the plastic part (bearing) on the right-hand side
of the door and screw it back into place on the left-hand
side. In the process, please ensure that the “lug” is point-
ing upwards (outside of the door) and that the left-hand
hole is positioned exactly over the large bore in the door.
The small pin on the underside of the plastic part
engages in the small bore.
9. Place the door to one side.
10. Ask your assistant to carefully tilt the freezer slightly
towards the rear (no more than 45 °) and to hold it in
position.
11. Unscrew the three screws with which the lower door
hinge is fastened and remove them.
12. Unscrew the left-hand foot and insert it into the large bore
on the right-hand side.
13. Unscrew the two screws at the bottom left and then
screw them into the outer holes on the right-hand side.
14. Fasten the lower door
hinge on the left-hand side
with the three screws.
15. Carefully tilt the freezer back towards the front.
16. Position the door precisely
on the lower hinge and
close it as straight as pos-
sible.
17. Insert the plastic sleeve
(bearing) into the door.
18. Insert the upper hinge into
the plastic sleeve (bear-
ing). In the process, pay
attention to the small plas-
tic ring.
19. Fasten the upper hinge
with the three screws.
20. Check whether the door can be opened and closed and
whether it is secured straight. Check whether the door
seal 5 is in air-tight contact all the way round. If neces-
sary, correct the fit of the lower hinge (step 14.).
21. Place the upper cover plate on the freezer with its
underside facing upwards.
22. Pull the small plastic part out on one side and insert it
again on the other side.
__RP62026_B4.book Seite 7 Dienstag, 8. Februar 2011 11:34 11