Silvercrest SED 3.7 C2 - Manual (Page 62)

59
GB
MT
SED 3.7 C2
NOTICE
► It may be that the hair grows back after a few days. The
reason for this is that these hairs were too short to be
removed during the last epilation session.
6) When you are fi nished with the treatment, place the speed switch 5
to “0”.
7) Clean the epilator head 2 as described in the section “Cleaning
and Care”.
8) Replace the protective cap 1 on the epilator head 2.
NOTICE
► If the epilator head 2 is damaged, discontinue all further use!
To order a new epilator head 2, please contact the service de-
partment (see chapter “Guarantee and service”). Please have
the IAM number ready (see operating manual cover).
To replace the epilator head 2, please pr oceed as follows:
― Press the two restraint fi xtures 3 together and at the
same time pull the epilator head 2 upwards.
― Press the new epilator head 2 onto the appliance.
Ensure that the gears on the epilator head 2 and on
the appliance mesh with each other. The epilator head 2
must audibly engage.