Silvercrest SEM 1100 A2 - Manual (Page 69)

67 SEM 1100 A2
GB
Technical data
Voltage 220 - 240 V ∼ / 50 Hz
Nominal performance 1100 W
Pump pressure approx. 1.5 MPa (15 bar)
Water tank (Max) 1.5 Litres
Energy consumption in standby
mode until automatic switch-off
approx. 31.3 Wh
Energy consumption in off -mode 0 Wh
Commissioning
1) Clean the sieve holder w, the measuring spoon 9, the espresso sieve 0 q,
the drip grill 8 and the water tank 1 as described in the chapter “Cleaning
and Care”.
2) Place the appliance on a level and heat-resistant surface. Ensure that a mains
power socket is in the vicinity.
3) Insert the drip grill 8 so that the red fl oat can protrude through the recess 7
in the drip grill 8.
4) Insert the plug into a mains power socket.
5) Proceed as follows before the fi rst use, so as to clean the internal pipelines:
6) Allow suffi cient water for about 5 cups of coff ee to fl ow through the appli-
ance. Refer to the chapter “Operation”.
7) Let steam generate for about 30 seconds. Refer to the chapter “Operation”.
NOTICE
► On the fi rst use it may be that the pump is already audibly working, noises
occur, but still no water is coming out of the appliance. In this case, turn
the steam control switch 2 in the direction “+” so that air can escape from
the pipelines of the appliance (the function rotary switch 5 stands at the
position “
“). After approx. 20 seconds the air will have escaped, the
noises disappear and water fl ows from the appliance.