Silvercrest SEM 1100 A2 - Manual (Page 71)

69 SEM 1100 A2
GB
MT
Heating up before every use
Before you can prepare an espresso or cappuccino, the appliance must be heated
up.
Switch the appliance on with the 1) on/off switch 3. The rotary switch 5 is at
the position „ “.
The red heating-up control lamp 2) i glows.
Wait until the green heating-up control lamp 3) 4 glows.
You can now make an espresso / cappuccino.
Heating up after an extended downtime
If you have not used it for some time, preheat the appliance as follows:
Fill the water tank 1) 1 with water.
Place either the large 2) q or the small espresso sieve 0 in the sieve carrier
w.
Insert the sieve carrier 3) w into the appliance by placing it at the marking
“INSERT” and then turning it anticlockwise to the marking “LOCK”.
Place a cup under the sieve carrier 4) w.
Close the steam regulation knob 5) 2 (turn it as far as it will go in the direction
“ - “).
Switch the appliance on with the on/off switch 6) 3.
The red heating-up control lamp 7) i glows.
Turn the rotary switch 8) 5 to the position “ ”. The pump begins to pump water
into the appliance. As soon as water fl ows from the sieve carrier opening, turn
the rotary switch 5 back to the position “
”.
As soon as the green heating-up control lamp 9) 4 glows, turn the rotary switch
5 to the position “ ”. Allow the water to fl ow for about 1 minute. It may be
that you need to empty the cup in between. For this, briefl y stop the process.
After approx. 1 minute turn the rotary switch back to the position “ 10) ”.
Wait until the green heating-up control lamp 11) 4 glows again. The warming-up
is concluded. You can now prepare espresso.