Silvercrest Digital Bathroom Scale - Manual (Page 4)

8 GB
J    Exhausted or damaged batteries
can cause caustic burns upon con-
tact with the skin. To avoid this,
always wear suitable protective gloves in these
circumstances!
J  Make sure you insert the batteries the right
way round (polarity). The “+” symbol must be
visible on the top of the battery.
J  Batteries do not belong in the household refuse
bin!
J  Every consumer is obliged to dispose of batter-
ies properly in accordance with the regulations.
J  Keep batteries away from children. Do not
throw batteries into a fire. Never short-circuit
them or take them apart.
J  Avoid contact with the skin, eyes and mucous
membranes if fluid is leaking from a battery. If
you come into contact with corrosive battery
fluids, flush the affected area thoroughly with
clean water and contact a doctor immediately.
J  Remove the batteries from the device if they
have not been used for a long period.
J  Remove exhausted batteries from the device
immediately, otherwise the batteries are likely
to leak.
J  If you disregard these instructions and advice,
the batteries may discharge beyond their mini-
mum voltage, thus increasing the chance of
leakage. If your batteries leak, remove them
from the device immediately to prevent it from
being damaged!
Q Preparation for use
Q   Removing the insulation strips
from the batteries
j  Slide open the battery compartment cover 11
and take it off the battery compartment 12 .
j  Remove the battery insulation strips.
j  Close the battery compartment 12 with the
battery compartment cover 11 .
j  If the scales do not appear to work, check that
the batteries have been inserted correctly and
reinsert them if necessary.
j  When you are inserting the batteries, make
sure that you do not permanently bend the
contacts.
j  Follow the instructions for inserting the batteries
as described in the section on “Replacing the
batteries”.
Q   Setting the unit of weight
note: The default unit of weight is the kilogram (kg).
The factory default setting for the scale as supplied
is “kg”.
j  Slide the switch 7 (kg/lb/st) to the desired
unit of weight.
Q   Setting the time
The value appears in the LC display 1 after
the insulation strips have been removed from the
batteries. The hour value flashes.
note: The time is shown in 24-hour format.
note: If you do not press a button within 30 sec-
onds, the time appears automatically as
.
j  Press the -button 3 or the -button 5 to set
the hour value.
j  Confirm your settings by pressing the SET but-
ton
4 . The minute value flashes.
j  Press the -button 3 or the -button 5 to set
the minute value.
j  Confirm your settings by pressing the SET but-
ton
4 .
Q   Switching the time
display on/off
The time display can be switched off to increase
battery life.
j  Press the SET button 4 for about 5 seconds.
The hour display goes out.
j  Press the SET button 4 for about 5 seconds
again. The value appears in the LC dis-
play 1 .
Safety advice / Preparing for use
54385_silv_Digitale_Personenwaage_Content_LB4.indd 8 08.03.11 11:18