Silvercrest 10-IN-1 REMOTE CONTROL SFB 10.1 B2 - Manual (Page 15)

- 13 -
the menu will close automatically. In the event of failure
the LCD display q shows briefly "ERROR" and waits for a
new code entry. Then you repeat step 4.
6. WiththeEXITbuttonyyoumovebackonelevelinthe
menu.
Programming by automatic code search
This process can take several minutes per device since all
codes for the selected device have to be gone through.
Therefore this method should only be used when the device
cannot be programmed via brand code search or direct
code input or if your device is not listed at all in the manufac-
turers directory with device code list.
Follow the steps listed below to carry out programming by
means of the automatic code search.
1. Press the device button e for the device that is to be con-
trolled (i.e. VCR).
2. Switch the device that is to be controlled with the remote
control on. With VCR/DVD/CD devices please insert a
tape and/or disc.
3. HolddowntheSbuttonrforalittlelongerthan3sec-
onds.“LANGUAGESETUP”appearsintheLCDdisplay
q
.Withtheorbuttontselect“CODESETUP”and
confirmwiththeOKbuttonl.
4. "ENTER CODE" now appears in the LCD display q. Press
the  or  button t until "SEARCH CODE" is shown in
the LCD display q. Point the remote control to the device
and then press the OK button l to access the mode "au-
tomatic code search".
5. The search begins. Thereby the device sends, one after
the other, the code numbers in ascending order. The infra-
red symbol 2# indicates this. Every search starts with the
currently programmed code.
6. When the device reacts by switching off press immedi-
ately the OK button l to save the relevent code. The LCD
display q shows briefly "OK".
7. Check to see if the majority of your device's functions can
now be controlled with the remote contol. If yes you have
most probably found the correct code. In the event that a
few functions are not working you can start the automatic
code search again beginning with step 1.
8. However if the device does not react any more you prob-
ably did not press the OK button l quick enough in step
6. Then press repeatedly the EXIT button y to exit the
menu and return to the standard display.
9. Now hold down the device button e of the device for
which you have just sought the relevent code. Below on
the right in the LCD display q will thereby be shown the
relevent code. Make a note of this number.
BDA_SFB 10.1 B2 - IAN-86342_gb.indd 13 06.12.2012 11:51:54