Silvercrest 10-IN-1 REMOTE CONTROL SFB 10.1 B2 - Manual (Page 26)

- 24 -
2. Individual favourites can not be deleted they can only be
overwritten.
Volume control
Vol +/—, (Mute switching)
Press the "VOL+" button to increase the volume. With the
"VOL —" button you reduce the volume. To mute the sound
press the -button h. A further press of this button turns
the sound back on.
If you have not set any other device as the target for the global
volume control, when you press the VOL +/- buttons j on
the URC the volume control of the TV set is addressed by
default, regardless of which device button e was previously
pressed. However, this does not apply to the following de-
vices: “AMP”, “DVD”, and “DSAT” since it can be assumed
that these devices are equipped with their own volume con-
trol.
For operation
> To operate one of the programmed devices with the URC
first press the corresponding device button e. Then point
the URC to this device and press the desired button.
> Put the number buttons o exactly as you do with the
original remote control. Before you make a two digit
entry press, if necessary, the button a.
 > PresstheSbuttonrandsubsequentlytheFAV/EPGbut-
ton1(tostarttheelectronicprogrammeguideofadevice
equippedwiththisfunction.
> If you press the S button r the date is superimposed for
10 seconds in the LCD display q below and on the right.
> Whilst you hold down one of the device buttons e the
active code for this device will be superimposed below to
the right in the LCD display q.
> Via the MENU button k you access the dialogue for the
setting of the respective target device.
> Press the illumination button d to switch the display and
button illuminations on and/or off.
All OFF
Tips:
With the button ALL OFF (all off) w all devices that
are switched on can be automatically switched off. This func-
tion can switch on again devices that have already been
switched off (depending on the device). For this, press and
hold the ALL OFF button w for a few seconds. It may take up
to 10 seconds before all devices are switched off. This will
only function under the following circumstances:
1. A visible connection exists between all the devices and
the URC.
BDA_SFB 10.1 B2 - IAN-86342_gb.indd 24 06.12.2012 11:51:57