Silvercrest SFE 450 B1 - Manual (Page 8)

- 6 -
Warning:
Remove the plug from the power source when
emptying the filter
d . This prevents an unintended
starting of the motor.
When the extracted juices suddenly become thicker,
or when you hear that the motor is running slower,
the filter
d must be emptied. When you have removed
the fruit pulp/vegetable mash, reassemble the
appliance.
Disassembly of the juice extractor
If you wish to disassemble the juice extractor, e.g.
to clean it, proceed as follows:
1. Remove the power plug from the wall socket
i .
2. Open the clasps r .
3. Remove the housing lid e with the stodger q .
4. Carefully lift up the juice container t . With this,
the filter d releases itself from the drive shaft f .
You can now take the filter d out of the juice
container t .
Cleaning and Care
Warning:
ALWAYS remove the power plug from the wall socket
before removing or installing accessories and before
cleaning the appliance. To avoid blockage of the
juice outlet and/or damage to the appliance, all
appliance and ancillary parts must be regularly,
and after every use, cleaned free of fruit pulp and
vegetable mash.
Note:
DO NOT use any aggressive cleaning agents to clean
the juice extractor. The appliance and its ancillaries
may not be cleaned in boiling water.
Warning:
To avoid receiving an electrical shock, NEVER
submerse the motor/appliance base
u in water
or other fluids.
• Switch the appliance off at the On/Off switch o .
• Soiling or overflowing fruit juices should be cleared
away immediately, as fruit stains are difficult to
remove later.
• For cleaning the appliance housing and the power
cable, use a cloth that is only lightly moistened.
• Clean the stodger q , the juice container t , the
separate juice catchment container h , the hou-
sing cover e and the container for pulp and po-
mace s in warm soapy water then rinse them
off carefully.
The stodger q , the juice container t , the housing
lid e , the separate juice collector h and the con-
tainer for fruit pulp and vegetable mash s are sui-
table for cleaning in a dishwasher and can be cle-
aned there. To clean the filter
d , use the supplied
nylon brush g :
• Turn the lid of the stodger q until the arrow points
to the opened lock on the stodger shaft. You
can now remove it. The nylon brush g is inside
the stodger q . To re-close the lid, place it on the
stodger so that the arrow points to the opened
lock .
Then turn it until the arrow points at the closed
lock . The lid now sits firmly.
• Hold the filter d (with the underside upwards)
under running water and clean it with the nylon
brush
g .
Colouring:
• Some fruits or vegetables could permanently dis-
colour parts of the juice extractor. This is not da-
maging and does not impair the appliance in its
functions.
IB_71771_SFE450B1_LB6.qxd 04.11.2011 12:24 Uhr Seite 6