Silvercrest SDG 800 B2 - Manual (Page 83)

SDG 800 B2 81
4.7 Material damage
Warning! Follow the instructions below to
prevent material damage.
• Never operate the steamer without
water.
• Ensure that there is never too much or
too little water in the appliance. Read off
the water level on the water level
indicator 13. It should always be
between MAX (1.2 l) and MIN (0.2 l).
• Only place the appliance on a level,
dry, non-slip surface so that the
appliance can neither fall over nor slide
off.
• Do not place the appliance immediately
underneath a suspended cupboard, as
steam escapes upwards and might
damage the furniture.
• Do not place the appliance on a hot
cooking ring.
• The appliance and accessories may not
be put in a microwave oven.
• Use only clean drinking water to
generate steam.
5. Unpacking and setting up
Note: As the appliance/the steam
generator 11 are supplied lightly greased,
a little odour and smoke may develop
when the appliance is used for the first time.
This will not cause any damage and will
stop after a short time. Please ensure
adequate ventilation during this process.
1. Remove the individual parts from the
packaging.
2. Check that the individual parts are
complete (see “1.2 Scope of supply” on
page 77) and are undamaged.
3. Clean the appliance thoroughly before
using it for the first time (see
“10. Cleaning and storing” on
page 90).
4. Place the appliance on a level, dry, non-
slip surface so that the appliance can
neither fall over nor slide off.
5. Pour 0.25 l of clean drinking water into
bottom part 12.
6. Put steam sleeve 8 on steam
generator 11. The narrow end of steam
sleeve 8 must face upwards.
7. Put collector 7 in bottom part 12.
8. Place steamer baskets 5 on bottom
part 12:
– ensure that the steamer baskets are in
the right sequence, as they are slightly
different sizes. Steamer basket 1 is
always on the bottom, steamer basket
2 on top of it and steamer basket 3
right on top. The number of the
steamer basket is shown on its
handles.
9. Place rice tray 4 in the top steamer
basket.
10.Place lid 3 on the top steamer basket.
11. Insert the power supply plug in a
suitable earthed power supply socket
(see “3. Technical data” on page 78).
12. Select a cooking time of 5 - 10 min. on
time selector 14.
The appliance starts heating up and
operating display 15 comes on.
13. Allow the appliance to cool down once
the set time has elapsed and then clean
it again (see “10. Cleaning and storing”
on page 90).
The appliance is now ready to use.
RP42772-Dampfgarer LB1 Seite 81 Dienstag, 8. Oktober 2013 5:30 17